Skid proof coating for wood, concrete and metal floors
Over half a century providing superior products and service!
State-of-the-art safety slip proof coating - ALLSAFE II
Takes the Slips and Falls Out of Danger Areas!
ALLSAFE II is an easy to apply, easy to use, incomparable single part non-skid coating system, providing superior scuff resistance and super durability.
This rubber base enamel coating provides a tough, spark-proof safety finish that exceeds OSHA requirements.
Use it on loading docks, ramps, ship decks, catwalks, tailgates & truck beds, food processing plants, locker rooms, stair treads, bus aisles, kitchens, swimming pools, ramps, retail areas and more!
THE MIRACLE OF "BUILT-IN" TRACTION!
ALLSAFE II contains a specially formulated resin material blended with millions of diamond hard silica grit which takes the slip and fall out of the most slippery surfaces.
These particles grab the soles of the feet walking across the floor, ramp, loading dock or any surface.
It is impossible to lose footing even when operating under the most hazardous conditions.
Prevents costly accidents along with the resulting litigation and the suffering such accidents cause.
Not a paint - it is a skid proof coating - the equivalent of 10 times the thickness of conventional floor paint.
Has its own primer "built-in" - labor is saved by using just one coat.
USDA authorized
Adheres and bonds to metal, wood and cement surfaces.
Spark proof
Makes clean up easy - its grippers are so microscopic the finish is relatively smooth
Easy to apply. A stiff bristled brush is all that is needed.
Dries in 5 - 8 hours. You will never have a tie up in production and traffic flow.
Unlike other so-called skid proof coatings, ALLSAFE will not peel or come up
Will last year after year after year
Every factory, business and institution must have ALLSAFE II for slip-proofing any accident prone areas.
ON LAND OR ON SEA! Indoor or Outdoor!
ALLSAFE II is resistant to alkali, detergents, mild acids, brake fluid, oil, grease, and more
ALLSAFE II will outlast ALL other so-called skid proof coatings
USDA approved for use in food handling areas
Also use for marinas - boat docks, ships, piers and on trucks.
The Miracle of "Built-In" Traction!
If you put ALLSAFE II under a microscope you will see a specifically formulated resin material blended with millions of diamond hard, silica grit which takes the slip and fall out of the slipperiest surfaces.
These particles act as 'snubbers' to grab the sole soles of the person walking across the floor, ramp, loading dock, truck bed, etc. They make it impossible to lose footing even when operating under the most hazardous conditions.
ALLSAFE II prevents costly accidents and resulting litigation as well as any needless suffering caused by such accidents.
A sampling of the Thousands who play it safe with ALLSAFE II
Baltimore Gas & Electric American Can Company Minneapolis Schools
Newsday Johns Manville Company University of Pennsylvania
Sysco Fenway Park New York/New Jersey Port Authority
U.S. Navy Safeway Stores Gates
American Tug & Barge Company International Hat Company Stokely Van Camp
Bridgeport Brass Company Los Angeles -Seattle Motor Express General Services Administration
General Electric Southwestern Bell Telephone Del Webb's Townhouses
Port of Everett Polk County Board of Education Calavo Growers of Californis
WHERE ORDINARY COATINGS FAIL, ALLSAFE II TRIUMPHS!
Celebrating 65 Years of Excellence!!!
Spark-proof coating/Inside and Outside
Carton of 4-1 gallon containers - $287.77
5 gallon pail - $353.45
[Minimum order: 8 gallons]
Free Shipping on orders $1,000 or more
Provides a permanent non-slip, non-skid surface
OSHA colors: Gray, Red, Yellow, Black, White, Sand
USDA Approved
Covers 50 to 75 square feet per gallon.
Dries in 5 - 8 hours.
To Order Click either: Net 30 Day Orders Credit Card Orders